N-pHuric GTO is for used for maintenance and improved water penetration.
For Use In
N-pHuric GTO is for use in irrigation, sprinkler and surface systems.,
For the use of N-pHuric GTO in drip, trickle, and mist systems for a clean out or shock treatment inject enough to reduce water pH to 2-2.5. Then operate at this pH level for 3 to 6 hours and then stop injection. Open the lines and flush the entire system with water only.
For the us of N-pHuric GTO in sprinkler and surface systems for maintenance and improved water penetration inject enough during the entire irrigation set to reduce water pH to 6.5 to remove approximately 50% of the bicarbonate content of the irrigation water. Approximately 85 to 90% of the bicarbonate content may be removed by reducing water pH to 4.5.
N-pHuric GTO is used at the higher rate of use each 2.5 gallon container will treat an estimated 5 acres depending on desired solution concentration per application.
Time to Kill
N-pHuric GTO is used as a water treatment additive to sprinkler, drip, trickle and mist systems and does not provide any killing action when used alone.
Nitrogen 15.0%, Sulfur 16.0%
CLEAN-OUT/ SHOCK TREATMENT: To unplug and eliminate deposits that may obstruct lines and emitters, inject enough N-pHURIC GTO® to reduce water pH to 2 to 2.5. Operate at this pH level for 3 to 6 hours and then stop injection of N-pHURIC GTO®. Open the lines (uncap or unclip ends) and flush entire system with water only.