For Use In
Meteor IGR may be used in areas where flea eggs, flea larva, or fleas are likely to be present including but not limited to pet quarters, pet beds, pet kennels, pet cages, carpets, rugs, upholstered furniture, tile, hardwood, bedrooms.
Note: Meteor IGR will not typically stain surfaces but a test application should be made before complete coverage of an area.
In order to prevent fleas and flea infestation, apply this product before the flea season. Users/applicators must ensure that they shake the solution well prior to each use.
Apply to areas where fleas, flea eggs and flea larvae are or are likely to be located such as surfaces where pets sleep, carpets, rugs and upholstered furniture (including on and under cushions and throw rugs) using a low pressure sprayer with a fan tip typically used for indoor applications.
1 ounce treats 1500 square feet of surface area.
Time to Kill
1 ounce per gallon of water
Prepare product as a diluted spray solution by adding 1 ounce of this product to 1/2 gallon of water in a
mixing container and agitate thoroughly. Then add an additional 1/2 gallon of water and agitate again,
resulting in one gallon of spray solution.
If there is already a high population of fleas at the biting (adult) stage, tank-mix this product with an EPA
registered product that is labeled for use to control fully developed/adult fleas. Add the product you are
tank mixing with this product to 1/2 gallon of water in the mixing container and agitate thoroughly. Then
add this product to the mixing container and agitate further. Finally, add an additional 1/2 gallon of water
to the mixing container to create one gallon of spray solution and agitate the mixture thoroughly.
Apply this product at the rate of 1 gallon diluted spray solution (see “MIXING DIRECTIONS” above) per