Shopping Cart Summary

 

Total: $0.00

Continue Shopping
FUSE Termiticide & Insecticide

    FUSE Termiticide & Insecticide

    Rating: Not yet rated
    Review(s) | Write a Review
    (0) Q&A's | Learn More
    $56.28 - $676.00
    Restrictions: NY
      Size/Description Price Qty
    7.5 oz bottle 7.5 oz bottle $56.28
    (2) 7.5 oz. bottles (2) 7.5 oz. bottles $109.04
    27.5 oz bottle 27.5 oz bottle $68.00
    (2) 27.5 oz. bottles (2) 27.5 oz. bottles $136.00
    137.5 oz bottle 137.5 oz bottle $340.00
    (2) 137.5 oz bottles (2) 137.5 oz bottles $676.00

    You may also need the following:

    Pest Control Safety Kit # 2 Pest Control Safety Kit # 2
      $76.43
    Total Price:$0.00
    Product Loading...
    " nest mates.

    Controls a long list of pest such as Ants, Boxelder Bugs, European Earwigs, Millipedes, Pill Bugs, Silverfish, Termites and more.

    FUSE™ may be used in and along the outside perimeter of structures and building construction to prevent and control termite infestations.

    If used according to the label each bottle of Fuse Termiticide will treat 240 linear feet.

    Modes of Action: Imidacloprid acts on post-synaptic nicotinic acetylcholine receptors in the nervous system of insects*

    Fipronil blocks GABAA-gated chloride channels in the central nervous system of insects*

    APPLICATION AS A TERMITICIDE

    FUSE™ may be used in and along the outside perimeter of structures and building construction to prevent and control termite infestations.

    USE INSTRUCTIONS

    For subterranean termite control, specific treatment recommendations may differ due to regulations, treatment procedures, soil types, construction practices and other factors. The purpose of chemical soil treatment for termite control is to establish a continuous treated zone(horizontal and/or vertical) between the wood and other cellulose material in the structure and the termite colonies in the soil. Follow all federal, state, and local regulations and treatment standards for protection of a structure from termites. The establishment of an aerial or above ground colony may require additional treatments to control the termites, as well as landscape modifications, and/or structural repairs to deny termites of a moisture source. Use a 0.067% to 0.13% dilution based on current recommendations. For a typical control situation, a 0.067% dilution is used. A 0.13% dilution may be used when a severe or persistent infestation exists.

    When treating adjacent to an existing structure, the applicator must check the area to be treated, and immediately adjacent areas of the structure, for visible and accessible cracks and holes to prevent any leaks or significant exposures to persons occupying the structure. People present or residing in the structure during application must be advised to remove their pets and themselves from the structure if they see any signs of leakage. After application, the applicator is required to check for leaks. All leaks resulting in the deposition of termiticide in locations other than those prescribed on this label must be cleaned up prior to leaving the application site. Do not allow people or pets to contact contaminated areas or to reoccupy contaminated areas of the structure until the clean-up is completed.

    Structures that contain wells or cisterns within the foundation of the structure can only be treated using the treated backfill method described in the treatment around wells and cisterns section of this label. Consult state and local specifications for recommended distances of wells from treated area, or if such regulations do not exist, refer to Federal Housing Administration Specifications (H.U.D.) for guidance.

    MIXING: Refer to MIXING TABLE for correct amount of FUSE™ to be used. Follow this procedure for mixing the termiticide dilution:

    1. Fill tank to 1/3 full.

    2. If using large sprayer, start pump to begin bypass agitation and place end of treating tool in tank to allow circulation through hose.

    3. Add appropriate amount of FUSE™.

    4. Add remaining amount of water.

    5. Let pump run and allow recirculation through the hose for 2 to 3 minutes or until the product is completely dispersed.

    Restrictions: NY

    Customer Reviews

    Average Customer Review: Not yet rated
    Write an online review and share your thoughts with others.


    There are no reviews
    Be the first to ask a question about this product.

    Be the first to ask a question about this product.

    Label (.pdf file)

    MSDS (.pdf file)

    epestsolutions is an Upfront Merchant on TheFind. Click for info.