New Vector-Flex 20:20 contains 20% permethrin and 20% piperonyl butoxide (PBO), which allow the product to maximize its effectiveness against mosquito populations - including species that transmit West Nile Virus. Vector-Flex 20:20 has the versatility to be mixed with both water and or oil, and is designed for ultra low-volume (ULV) and thermal fogging applications. It controls mosquitoes and flies in residential, industrial and commercial and urban areas, parks, campgrounds, woodlands, athletic fields, golf courses, playgrounds, and more.
Vector-Flex 20:20 is one of the best insecticides that specifically target mosquitos, destroying the populations easily and effectively. Just place the product in a fogging or ULV (Ultra-low volume) unit, turn it on and spread the Vector-Flex 20:20 insecticide on the desired property. Can be applied from any type of vehicle. Just take into account weather conditions and you can clear the area of all those pesky mosquitos.
FOR BEST RESULTS treat when mosquitoes or insects are most active and weather conditions are conducive to keeping the fog near the ground e.g. cool temperatures, and consistent wind speeds are not greater, than 10 mph. Applications during cool hours of night or early morning are usually preferable. Do not retreat the same site more than once in 12 hours. Do not apply more than 0.18 lbs. of permethrin per acre per year to any site. More frequent treatments may be made to prevent or control a threat to public and/or animal health determined by a state, tribal or local health or vector control agency on the basis of documented evidence of disease causing agents in vector mosquitoes or the occurrence of mosquito-borne disease in animal or human populations, or if specifically approved by the state or tribe during a natural disaster recovery effort. Vector-Flex 20:20 can be applied over specific growing crops and range grasses prior to harvest for the control of adult mosquitoes and biting flies within or adjacent to these areas.
Application can only be made where the following crops are present: Almonds; Leafy Vegetables (except Brassica); Apples Lettuce, head; Broccoli; Mushrooms; Brussels sprouts; Onions, dry bulb; Cabbage; Peaches; Celery; Pears; Cauliflower; Peppers, bell; Cherries; Soybeans; Corn, fodder; Tomatoes; Corn, forage; Vegetables, cucurbit; Corn; grain; Walnuts; Eggplant; Range Grasses
Do not allow spray treatment to drift on pastureland, cropland, (other than crops listed) or water supplies. In treatment of corrals, feedlots, animal confinements/houses, swine lots and zoos, cover any exposed drinking water, drinking fountains and animal feed before application. Vector-Flex 20:20 provides effective control of adult mosquitoes, black flies, gnats, biting and non-biting midges, stable flies, horse flies, deer flies, sheep flies, horn and heel flies, and nuisance flying insects such as houseflies.Air temperatures should be greater than 50° F when conducting all types of applications.
Vehicle-Mounted ULV Cold Aerosol Generators (Cold Fog): Apply through non-thermal ULV application equipment and base all acreage calculations on the equipment manufacturers recommended swath width. Spray equipment must be adjusted so the volume median diameter or mass median diameter is less than 30 microns (Dv 0.5 < 30 μm) and that 90% of the spray is contained in droplets smaller than 48 microns (Dv 0.9 < 48 μm). Directions from the equipment manufacturer or vendor, pesticide registrant or a test facility using a laser-based measurement instrument must be used to adjust equipment to produce acceptable droplet size spectra. Application equipment must be tested at least annually to confirm that pressure at the nozzle andnozzle flow rates(s) are properly calibrated. Apply at a rate not to exceed 0.007 pounds of permethrin per acre. An optimum swath is created when Vector-Flex 20:20 is applied from a truck being driven perpendicular to the wind direction. Direct the spray head of the equipment to ensure an optimum distribution of the spray cloud throughout the area. For best results, apply when insects are most active and meteorological conditions are conducive to keeping the spray cloud near the ground. An inversion of air temperatures and a light breeze of approximately 1 to 3 mph is preferable. During applications consistent ground wind speeds should not exceed 10 mph. Application of this product during cooler hours of the night or early morning is recommended.Vector-Flex 20:20 may be applied through all ULV Cold Aerosol Generators, or other similar equipment designed for non-thermal ULV aerosol applications. The desired application rate may be obtained from the chart below or by altering the dilution rate of Vector-Flex 20:20, the flow rate of the insecticide from the application equipment and the vehicle speed. Some examples are provided in the following chart. When an alternate rate is required, adjust the flow rate accordingly, provided the droplet size and spectrum remain within the label specifications.
Note: Before making the first application in a season, it is advisable to consult with the state or tribal agency with primary responsibility for pesticide regulation to determine if other regulatory requirements exist.
Restrictions: AK, AZ, AR, CA, CT, DE, HI, IN, KY, LA, ME, MD, NE, NV, NH, NM, NY, OH, PA, RI, TN, VT, WV, WI, WY
|Average Customer Review: Not yet rated|
Write an online review and share your thoughts with others.